Bevel Cutting - Makita M4302 Instruction Manual

Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest
the base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.

Bevel cutting

CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
► 1 . Hex wrench 2. Hex bolt
Loosen the bolt on the back of the base with the hex
wrench and slide the base backwards.
► 1 . Edge of housing 2. Graduation
Tilt the base until the desired bevel angle is obtained.
The edge of the housing indicates the bevel angle by
graduations. Then check the contact between the back
edge of the blade and the roller. Now tighten the bolt to
secure the base.
Front flush cuts
► 1 . Hex wrench 2. Hex bolt
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then
tighten the bolt to secure the base.
Cutouts
1
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
2
6 ENGLISH
2
1
1
2