Operation - Makita DEADML810 Instruction Manual

Appliance / battery protection
system
The appliance is equipped with the protection system.
This system automatically cuts off power to extend
appliance and battery life. The appliance will automati-
cally stop during operation if the appliance or battery is
placed under one of the following conditions.
Overload protection
When the appliance is operated in a manner that
causes it to draw an abnormally high current, the appli-
ance automatically stops without any indication. In this
situation, remove and install the battery cartridge when
using with DC power, or push the breaker restart button
when using AC power. Then turn the appliance on to
restart.
► 1. Breaker restart button
Overdischarge protection
When the battery capacity becomes low, the LED
lights go out except a part of LEDs as illustrated. Then
approximately five to ten minutes later, the system auto-
matically cuts off power. In this situation, remove the
battery cartridge from the appliance and charge it.
1
Hole for padlock
For anti-theft of battery cartridges, hole for padlock is
provided.
1
► 1. Hole for padlock

OPERATION

CAUTION:
This appliance is intended for
commercial use. Do not use the appliance for
household purpose.
Turning on / off the appliance
Press the power switch button to turn on the appliance.
Press the power switch button again to turn off the
appliance.
1
► 1. Power switch button
NOTE: The appliance turns on at the same mode as
the last setting.
7 ENGLISH