Operation - Makita DML805 Instruction Manual

Use of non-genuine Makita batteries, or batteries that
have been altered, will void the Makita warranty for the
Makita tool and charger.
Use with AC power:
Connect the plug to a power supply.
Turning on LED light
Press the switch once, the light shines brightly (high
mode). Press the switch again, the light shines mildly (low
mode). To turn off the light, press the switch once again.
Battery protection system
The tool is equipped with a battery protection system to
extend battery life.
When the battery becomes low, the LED lights go out
except one LED (the one on the second line center).
Then, after approximately five to ten minutes later, the
system automatically cuts off power.
6
1. Plug (the shape
may differ from
country to country)
1
1. Switch
1

OPERATION

CAUTION:
• This worklight is intended for field work use. Do not use
the worklight for household purpose.
• Always put the tool on flat and stable place. Otherwise
a falling accident may occur.
Adjusting the angle of the worklight
Loosen the knobs on the both side. Adjust the angle of
the worklight. Then tighten the knobs again.
Using with tripod or vise (optional
accessories)
CAUTION:
• Read carefully the instruction manuals of the
accessories before using them with the worklight.
• When using with tripod or vise, do not let the total height
exceed 1.75 m (5' 10").
You can put the worklight on the tripod or vise to facilitate
the operation.
1. Knob
1