Page 2
Thank you and congratulations on choosing Parweld. This Owner’s Manual is designed to help you get the most out of your Parweld products. Please take time to read the Safety precautions. They will help you protect yourself against potential hazards in the workplace. With proper maintanance this equipment should provide years of reliable service.
(leather, heavy cotton, or wool) and foot Do not touch electrode if you are in contact with the work, ground, or another electrode from a different machine. Use only well-maintained equipment. Repair or replace damaged parts at once. Maintain unit according to manual. www.parweld.com...
Page 5
HOT PARTS can cause severe burns. Do not touch hot parts with bare handed. Allow cooling period before working on gun or torch. To handle hot parts, use proper tools and/or wear heavy, www.parweld.com...
2. Water cooler selector switch. This allows the hose, a Parweld MIG torch, and a 3.0m work cable water recirculation pump and the flow switch with clamp. Digital meters display the actual welding voltage and amperage and the machine has additional controls for adjustment of burn back and soft starting.
21. Location for control socket if machine is fitted with Push Pull torch fitted to XTM403SW) 22. Torch connector The Euro connector provided the external 10. Filling spout for coolant Only use Parweld connection for the welding torch Ultracool 23. Soft start adjustment which controls the acceleration of the wire feed motor when the arc starts to reduce spatter and give a cleaner arc initiation.
The The green/yellow wire in the input cable connects gas hose should be lead off to the outlet connection of to the frame of the machine. This ensures proper the gas regulator. www.parweld.com...
1.2 l/min is recommended. 4. Slide the wire spool all the way onto the shaft and Parweld recommend the use of its XTS water refit the plastic retaining nut. recirculation system designed specifically for use with all water cooled MIG, TIG and Plasma welding torches.
Selector switch on the front panel is moved to the above steps. on position. b) The water tank is filled with Parweld Ultra Cool 6.1 Feeding wire electrode Note when triggering, the electrode and drive mechanism are electrically “LIVE” relative to work and ground and remain “LIVE”...
Burn back adjustment. when welding at high amperages the wire can often burn back onto or close to the contact tip to prevent this happening you can increase the burn back control (18) located inside the wire spool cover. www.parweld.com...
Page 12
– weld metal melting Select lower voltage Increase and/or through base metal and range and reduce wire Resulting in holes where maintain steady travel hanging underneath feed speed. no metal remains. speed. weld. Increase travel speed. www.parweld.com...
Page 13
Incorrect liner Blocked liner Bird nesting Burn back Bird nesting Excessive feed roll pressure Incorrect or blocked liner Incorrect contact tip size Contact tip overheating Restriction in torch cable Misaligned drive rolls or wire guides Excessive cable kinkage www.parweld.com...
• Fitted with standard 3 /89 BSP inlet and outlet connections Stock Code Description 706101 Flow Meter Mixed Gas 25 lpm (MIG) Gas flow Tester • Designed to check gas flow at the front of Mig Torches. Stock Code Description 806001 Gas flow Tester www.parweld.com www.parweld.com...
Parweld to be defective. Parweld makes no other warranty, express or implied. This warranty is exclusive and in lieu of all others, including, but not limited to any warranty of merchantability or fitness for any particular purpose.