Makita DUN461W Instruction Manual page 12

10. Attach the shear blades to the tool, and then
tighten 3 screws with the screwdriver.
► 1 . Screw
11.
Remove the screw inserted into the hole on the
shear blades in step 9, and then tighten it to fix the
shear blades.
NOTICE:
If the shear blades do not operate prop-
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
NOTICE:
If the parts other than the shear blades
such as the crank are worn out, ask Makita
Authorized Service Centers for parts replacement
or repairs.
Installing or removing the chip
receiver
Optional accessory
CAUTION:
When installing or removing the
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
CAUTION:
Attach the blade cover before
installing or removing the chip receiver.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier. It can be installed on
either side of the tool.
1. Align the holes on the chip receiver with the nuts
on the shear blades.
1
► 1 . Nut
2. Hook the claws of the chip receiver to the groove
on the shear blades.
1
► 1 . Claw 2. Groove
3.
Press the levers on the chip receiver, and then
hook the claws on the other side to the groove on the
shear blades.
► 1 . Lever
To remove the chip receiver, press the levers to release
the claws.
► 1 . Lever
12 ENGLISH
1
1
1
2