Makita DUN461W Instruction Manual page 11

4. Prepare the crank and new shear blades.
► 1 . Crank 2. Shear blades
5. Remove the blade cover, and then attach it to the
new shear blades.
6. Apply a small amount of grease to the periphery of
the crank. Attach the washer, gear, and the crank to the
pin in order.
1
2
3
► 1 . Crank 2. Gear 3. Washer 4. Pin
1
2
4
7. Adjust the crank so that the 2 small holes on the crank
are lined up on the alignment line as shown in the figure.
1
► 1 . Alignment line 2. Small hole
8. Slide the shear blades so that the hole on the
guide plate is positioned at the center of the rings of
blades.
► 1 . Guide plate
9.
Insert the screw removed in step 2 into the hole on
the shear blades through the hole on the blade cover.
1
► 1 . Hole
11 ENGLISH
2
1