Table of Contents
Advertisement
6.
Use motor pulley to rotate cutterhead until
one knife or insert is at TDC (its highest point
during rotation), as shown in Figures 75–76.
7.
Use outfeed table handwheel to set outfeed
table so knife or insert barely touches straight-
edge, as shown in Figure 76.
Top Dead
G0813/G0814
Center
Top Dead
G0814X
Figure 75. Knife or insert at TDC.
Straightedge
Outfeed
Bottom Dead
Straightedge
Outfeed
Figure 76. Using straightedge to check outfeed
table height.
8.
Tighten outfeed table lock so outfeed table
will not move during operation.
9.
Re-install cutterhead guard, fence, and
cabinet rear access panel.
-52-
Center
G0813/G0814
Infeed
G0814X
Center
Infeed
Calibrating Depth
Scale
The depth scale can be calibrated or "zeroed" to
make sure the cutting depth shown on the scale
matches the actual cutting depth (per pass).
Before beginning, set outfeed table height as
To calibrate the depth scale:
described in Setting Outfeed Table Height.
1.
Set the outfeed table height as described in
Tools Needed
Setting Outfeed Table Height.
Straightedge ...................................................... 1
Phillips Screwdriver #2 ...................................... 1
2.
Place a straightedge across the infeed and
Open-End Wrench 12mm .................................. 1
outfeed tables.
To calibrate depth scale:
3.
Adjust the infeed table until it is level with the
outfeed table, as shown below.
1.
DISCONNECT MACHINE FROM POWER!
4.
Using a screwdriver, precisely adjust the
2.
Place straightedge across infeed and outfeed
scale pointer to "0".
tables (see Figure 77).
G0813/G0814
Straightedge
Outfeed
G0814X
Straightedge
Outfeed
Figure 77. Infeed table adjusted even with
outfeed table.
Model G0813/G0814/G0814X (Mfd. Since 10/19)
Qty
Infeed
Infeed
Advertisement
Table of Contents
