Led Indicators - Honeywell Dolphin 6510 User Manual

We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in damage not
covered by the warranty.
Step 2. Charge the Batteries
Dolphin 6510s ship with the battery pack
significantly discharged of power. Charge the
battery pack with the Dolphin charging cable until
the LED turns green (red while charging). The
average charge time for a fully depleted battery is
7 1/2 hours. It takes less time if the battery has
some charge.
1. Attach the appropriate plug adapter to the
plug of the power cable.*
2. Insert the plug into the appropriate power
source.
3. Plug the Dolphin power cable into the
Power Jack (see page 3-11) on
end of the unit.
Important: Removing the battery from the terminal erases
all non-persistent memory.

LED Indicators

Charging
Red LED On
Battery is fully charged
Green LED On
*This power cable can also be used to power the
Dolphin 6510 while in the
(Model 6510-HB)/eBase (Model 6510-EHB)
Device (see page 10-1).
We recommend use of Honeywell peripherals, power cables, and power adapters compiled with
L.P.S. Use of any non-Honeywell peripherals, cables, or power adapters may cause damage not
covered by the warranty.
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating
!
wet components may cause damage not covered by the warranty.
DC
the bottom
Dolphin HomeBase
2-2