Honeywell Dolphin 6510 User Manual page 20

Stylus
Dolphin 6510 terminals ship with a stylus inserted in a loop on the hand strap. Store the stylus in
the hand strap when you're not using it; see
Installing Memory Cards
The Dolphin 6510 supports Secure Digital (SD) memory cards from 512MB up to 8GB in capacity. The
recommended SD cards are 2GB and 4GB ATP
purchase these SD cards by contacting your Honeywell sales representative.
To install an SD card:
1. Remove the battery door on the back of the unit.
2. Remove the battery.
3. Insert the SD card with the label facing upward by pressing down the small pin and sliding the SD
card into the SD card connector until you feel it lock into position. The notch on the SD card should
be in the upper-right hand corner.
Note: If your unit has trouble reading the SD card, the SD card may not have been inserted correctly. If depressing
the small pin allows the card to eject, the card was not properly inserted and "locked in."
4. Replace the battery and battery door.
5. Tap the Power or SCAN key to resume operation.
6. To verify that the operating system recognizes the new memory card, open Windows Explorer and
navigate to My Device\Storage Card.
To remove an SD card:
1. Remove the battery door on the back of the unit.
2. Remove the battery.
3. Press the SD card towards the front of the terminal until you hear a click to confirm that it has
unlocked. The card will stops when it hits the pin.
4. Depress the small pin at the edge of the card. The card will pop out enough for you to grab its edge.
Using the Stylus
®
-brand, which have been tested for reliability. You can
SD Card
SD Card
on page 2-5.
Pin
3-9