Routing Control; System Standby; One Touch Record - Asus Aaeon UP Xtreme UPX-WHL01 User Manual

5.1.2

Routing Control

Command Feature: This feature is used to control the routing of the HDMI network by
controlling CEC Switches.
The following messages are used for the Routing Control feature: <Active Source>,
<Inactive Source>, <Request Active Source>, <Set Stream Path>, <Routing Change>,
<Routing Information>.
5.1.3

System Standby

Command Feature: The broadcast message <Standby> can be used to switch all CEC
devices to standby. The following message is used for the System Standby feature:
<Standby>
OpCode Value
<Standby> 0x36
5.1.4

One Touch Record

Command Feature: This feature allows the user to easily start a recording of the source
that is being displayed on the TV, just by selecting a Recording Device and giving the
record command.
The following messages are used for the One Touch Record feature: <Record Off>,
<Record On>, <Record Status>, <Record TV Screen>.
OpCode Value
<Record 0x0B
Off>
Table Continues on Next Page
CEC Client Installation
Description Parameters
Switches one or None
all devices into
standby mode.
Can be used as
a broadcast
message or be
addressed to a
specific device.
Description Parameters
Requests a None
device to stop a
recording.
Response
Switch the device into
Standby. Ignore the
message if already in
standby.
Response
Exit 'Recording' state.
Supported
Yes
Supported
Yes
35