Adjusting Trim Angle For Hydro Tilt Models - Yamaha 60F Owner's Manual

use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
UP
DN
1
1. Power trim and tilt switch
1. Power trim and tilt switch
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
" " (down).
ZMU03110
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EMU27891
Adjusting trim angle for hydro tilt
models
EWM00490
WARNING
Stop the engine before adjusting the
G
trim angle.
Be sure all people are clear of the out-
G
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
1. Stop the engine.
2. Place the tilt lock lever in the release po-
sition.
Operation
UP
DN
1
ZMU04515
35