Trim Rod (Tilt Pin); Tilt Lock Mechanism; Tilt Support Lever For Power Trim And Tilt Or Hydro Tilt Model; Top Cowling Lock Lever(S) (Turn Type) - Yamaha 60F Owner's Manual

Basic components
A
1
2
1. Trim tab
2. Bolt
Bolt tightening torque:
36.0 Nm (26 ft-lb) (3.6 kgf-m)
EMU26261

Trim rod (tilt pin)

The position of the trim rod determines the
minimum trim angle of the outboard motor in
relation to the transom.
EMU26312

Tilt lock mechanism

The tilt lock mechanism is used to prevent
the outboard motor from lifting out of the wa-
ter when in reverse gear.
16
B
ZMU03097
ZMU02526
1. Tilt lock lever
To lock it, set the tilt lock lever in the "
(lock) position. To release, push the tilt lock
lever in the " " (release) position.
EMU34460
Tilt support lever for power trim and
tilt or hydro tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
EMU26372

Top cowling lock lever(s) (turn type)

To remove the engine top cowling, turn the
lock lever(s) and lift off the cowling. When in-
stalling the cowling, check to be sure it fits
properly in the rubber seal. Then lock the
cowling again by returning the lever(s) to the
lock position.
1
ZMU02527
"
ZMU03194