Table of Contents
Advertisement
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Removing or installing diamond
wheel (optional accessory)
CAUTION:
•
Use only the Makita wrench and hex wrench to
install or remove the wheel.
2
3
► 1. Outer flange 2. Wrench 3. Hex wrench
To remove the wheel, hold the outer flange with the
wrench and loosen the hex bolt clockwise with the hex
wrench. Then remove the hex bolt, outer flange and
wheel.
► 1. Inner flange 2. Diamond wheel 3. Outer flange
4. Hex bolt
To install the wheel, follow the removal procedure in
reverse. Always install the wheel so that the arrow on
the wheel points in the same direction as the arrow
on the blade case. BE SURE TO TIGHTEN THE HEX
BOLT COUNTERCLOCKWISE SECURELY.
Water flow
Only for tool with a vinyl tube
(optional accessory)
► 1. Tube holder 2. Vinyl tube
Put the vinyl tube into the tube holder just like screwing
in so that used diamond wheel cannot be obstructed or
interrupted.
1
OPERATION
CAUTION:
•
•
For tool without a vinyl tube
1
(optional accessory)
2
3
4
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the wheel making any contact. Then
turn the tool on and wait until the wheel attains full
speed. Now simply move the tool forward over the work-
piece surface, keeping it flat and advancing smoothly
until the cutting is completed. Keep your cutting line
straight and your speed of advance uniform.
6 ENGLISH
THIS TOOL SHOULD ONLY BE USED ON
HORIZONTAL SURFACES.
Be sure to move the tool forward in a straight
line and gently. Forcing and exerting excessive
pressure or allowing the wheel to bend, pinch
or twist in the cut can cause overheating of the
motor and dangerous kickback of the tool.
1
2
Advertisement
Table of Contents
