Table of Contents
Advertisement
FUNCTIONAL
DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting the depth of cut
2
► 1. Wing bolt 2. Base
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
CAUTION:
•
After adjusting depth of cut, always tighten the
wing bolt securely.
Sighting
► 1. Edge of the front base
Align the edge of the front of the base with your cutting
line on the workpiece.
Switch action
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
► 1. Lock button / Lock-off button 2. Switch trigger
For tool with lock button
1
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
push in the lock button and then release the switch
trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
CAUTION:
•
Do not pull the switch trigger hard without press-
ing in the lock-off button. This can cause switch
breakage.
For tool without lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Hex wrench storage
1
1
► 1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
5 ENGLISH
1
2
Advertisement
Table of Contents
