Table of Contents
Advertisement
To install using the spacer:
1.
Use the included screws or the VHB tape to secure the spacer on the surface.
2.
Remove the battery compartment on the main sensor body and attach it to the spacers using the included screws.
NOTE: Make sure the arrows on the spacers point toward the grey side of the sensor body.
90° Magnet Mount
Due to the design limitation of the magnet mount, it only allows users to permanently mount it if the surface between the door and frame is on a single axis. To
overcome this limitation and allow users to mount the magnet if the frame is perpendicular to the door, the 90° magnet mount can be used.
7
Advertisement
Table of Contents
