Table of Contents
Advertisement
Since the magnet mount is made of plastic, a high amount of torque can be damaging. Below is the recommended dimensions and parameters for the install.
1. Drill a hole 2.0mm (soft wood) ~ 2.5mm (hard wood).
2. Use 0.5 N-m (soft wood) ~ 1.0 N-m (hard wood) to screw it
VHB Tape
Alternatively, the double-sided VHB tape can be used for a less permanent solution. Note that this option doesn't ensure the security of the sensor.
Mounting Using Optional Accessories
While the options above cover most of the installation scenarios, there might be cases where additional accessories are required.
The MT20 box comes with optional accessories as outlined below:
5
Advertisement
Table of Contents
