Advertisement
S-Quad
Tools
An extractor tool allows removal and fitting of the S-Quad device
head into the base. By fitting a screw-on adaptor, the tool can be
used to remove the sensor dust cover.
To remove the S-Quad
Fit the tool onto the S-Quad. Turn S-Quad anticlockwise until it
stops and then remove the S-Quad from the base.
To fit an S-Quad
Fit the S-Quad on to the tool. Offer S-Quad to base and rotate
clockwise until it moves upwards on to the base and rotate it
again until it clicks and goes no further, the lines on the base and
S-Quad will align.
Base
4188-779 issue 8-7_08/10_S-Quad _Part 1
www.acornfiresecurity.com
S-Quad
Tool
S-Quad
Tool
www.acornfiresecurity.com
To fit the dust cover using tool
Place the dust cover onto the tool inside the cradle. Offer the
cover to the S-Quad, locate and push to fit it onto the assembly.
Withdraw the tool when the dust cover is in place.
Tool
To remove the dust cover using tool
A dust cover remover tool must be fitted to the main tool to
extract the dust cover. Press the pad of the dust cover remover
tool onto the dust cover, this creates an air tight grip, to allow the
cover to be pulled off from the S-Quad.
Tool
Data and Installation
Dust cover
Dust cover
Dust cover
remover tool
3
Advertisement
