Automatic Detection Of Fire - Honeywell GENT Vigilon Plus Series Operating Instructions Manual

Automatic detection of FIRE

Automatic detection of FIRE
A fire in your protected premises is automatically sensed at any
one of the fire detection devices installed in the building, such as
a sensor or a fire input from an interface. The control panel
actions the alarm sounders in the system and at the same time
gives the details of the fire event. The event indication is repeated
at all repeat indicator panels in the system.
Panel
buzzer
The 'Zone indicators' are not applicable at a Vigilon Plus Network Node
1
Zones
Fault
1stFIRE:MCP:Zone 1
Power Fault
First Fire occurred at:
System Fault
Time: 15:43.10
Delay
Test
Disablement
14
www.acornfiresecurity.com
On
15:45
Wed 16 March 2016
Previous Next
If configured this light indicate there is an active Fire routing
output to Alarm Receiving Centre to initiate Fire fighting action.
www.acornfiresecurity.com
With the panel door open:
†
To cancel
buzzer
To silence
alarms
Flashing
To reset
Fire
system
Verify
Sounder
Active
Fire
Routing
O/P
Fault/Dis
Power
Record
the event
You can stop the panel buzzer from
sounding.
CANCEL
BUZZER
Press:
Display reads: 'Buzzer cancelled'
When the emergency is over the alarm
sounders can be silenced.
SILENCE
ALARMS
Press:
Display reads: 'Alarms silenced'
To return the system to normal condition
clear any residual smoke or heat from
sensors and reset element or replace the
glass in any manual call point where the
glass was broken.
Ensure the fire system is checked by
your servicing organisation if there
has been fire damage in the protected
area.
RESET
Press:
Display reads 'System being Reset -
please wait....'
Make an entry in the log book of the
event for future reference.