How To Reset All Faults; How To 'Find' Mains Powered Daus On A Loop - Honeywell GENT COMPACT-MAINS-DAU Commissioning Instructions

Commissioning instructions

How to reset All Faults

All fault indications at the Mains Powered DAU which are either latched faults or non-latched faults can be cleared by pressing the
reset push button on the Main Control Board. This will erase the fault indications at the Mains Powered DAU, reactivate the local fault
relay and stop the local fault buzzer from sounding. If the fault should still remain then the indications will reappear after a few
minutes.
SW1
RESET
Press once to clear the
all Fault indications.

How to 'Find' Mains Powered DAUs on a loop

If you need to know the address(es) of the Mains Powered DAU(s) on a loop circuit, then go to the Vigilon Compact VA panel and
carry out a Find Device test. It is made easier if there are two people in communication with each other, while one person walks
around the site and follow the devices as per As fitted wiring drawings, the other person operates the panel controls.
The following procedure assumes no password access is required at the Vigilon Compact VA panel:
Press the Menu On/Off button and then [Test/Eng] ->[Loop] ->[Find Dev], now enter a CARD number n to select the loop
a
circuit on which the Mains Powered DAU(s) are located, then select the [Start] option and type in a device number, if known, or
as an alternative enter device number 1 and select [Enter]. The display shows the device and loop numbers:
Number 1 on Loop 1
Select [Next] to find the next device on the loop if starting from address 1. At any stage if the previous device needs to be found
b
then select [Previous].
A found device will give a visual or audible indication and at the Mains Powered DAU there will be a flashing green LED on the
MCB.
FIND DEVICE indication
20
www.acornfiresecurity.com
All Fault indications
are cleared
fault indicators
buzzer
Mains Powered DAU
ON
by Honeywell
ON XX/XX/XX
1 2 3 4 5 6 7 8
OFF
www.acornfiresecurity.com
Fault indications will reappear
if faults should remain.
Wait for up to
3 minutes
Medium flashes
0.5s ON - 0.5s OFF
green
N PE L
L1 01 L2 02 I/A I/B O/A O/B I/A I/B O/A O/B IN+ IN- E 0V A 0V T 0V NO COM N/O COM N/C 0UT 0V OUT 0V S1+ S1- S2+ S2-
P2
VIGILON L N LOOP AUDIO LOOP PA LOOP EVAC ALERT TEST AUX FAULT LINE LINE SPEAKER SPEAKER FS3 3.15A(T)
LOCAL 1 2
PB1 PB3 PB5 AUDIO PB12 PB13 PB14 RELAY RELAY OUT1 OUT2 PB10 PB11 Mains fuse
PB15 PB2 PB6 PB7
PB4 N L
VIG CONFIG
DISABLE
P12 ENABLE
1A0 (F)
FS1
1A0 (F)
FS2
P1
AMP 1
P22 P2
P1
P3
AMP 2
P21
P2
P1
PB9 P11 PB16 CAN CAN ACS CONFIG ACS CONFIG SW1 P7
DISABLE H DISABLE BATT
EMIC 0V P6
ENABLE 0V Tx Rx L ENABLE POWER
RESET
P9 SUPPLY
fault indicators