Makita EE400MP Instruction Manual
Edger attachment
Hide thumbs
Also See for EE400MP:
- Instruction manual (72 pages) ,
- Original instruction manual (60 pages) ,
- Original instruction manual (76 pages)
Table of Contents
Related Manuals for Makita EE400MP
Summary of Contents for Makita EE400MP
- Page 1 Edger Attachment EE400MP INSTRUCTION MANUAL Original Instruction Manual WARNING: Before use, read this booklet and the instruction manual of the power unit. Failure to follow the warnings and instructions may cause serious or fatal injury.
-
Page 2: Table Of Contents
Foreword Wear protective gloves. Thank you very much for purchasing Makita edger attachment. This attachment is designed to be mounted on Makita power unit mentioned in this instruction manual. Wear sturdy boots with nonslip soles. Before use, please read this booklet and the instruction manual of Steeltoed safety boots are recommended. -
Page 3: Approved Power Unit
Approved power unit • Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. • Never attempt to modify the attachment. This attachment is approved to use only with the following power •... -
Page 4: Assembly And Adjustment
• Do not attempt any maintenance or repair not described in this • Do not overreach. Keep proper footing and balance at all times. booklet or the instruction manual of the power unit. Ask Makita Watch for hidden obstacles such as tree stumps, roots and authorized service center for such work. -
Page 5: Operation
Supply grease (Shell Alvania 2 or equivalent) to the gear case (1) through the grease hole (2) every 30 hours of operation. (Genuine Makita grease may be purchased from your local Makita dealer.) -
Page 6: Storage
Supply grease (Shell Alvania No.2 or equivalent) every 30 hours of operation. Overall inspection • Tighten loose bolts, nuts and screws. • Check for damaged parts. Ask Makita authorized service center to replace them. Storage WARNING: Follow the warnings and precautions in the chapter “Safety precautions”... -
Page 7: Maintenance Schedule
A twig is caught between the cutting blade Remove the foreign matter. and the protector. The drive system does not work properly. Ask Makita authorized service center to inspect and repair it. The unit vibrates abnormally. The cutting blade is bent, worn or broken. - Page 8 Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan www.makita.com 885310A888...