Advertisement
3.
Attach two long crossmembers to support
legs with (4) M6-1 x 16 hex bolts, 6mm flat
washers, 6mm lock washers, and M6-1 hex
nuts (see Figure 3).
4.
Attach two short crossmembers to support
legs with (4) M6-1 x 16 hex bolts, 6mm flat
washers, 6mm lock washers, and M6-1 hex
nuts (see Figure 3).
Long
x 8
Crossmembers
Figure 3. Long crossmembers and short
crossmembers attached to support legs.
5.
Lay table on its side and install (1) M8-1.25 X
1
⁄
" adjustable foot with (1) M8-1.25 hex nut
1
2
on each support leg, as shown in Figure 4.
Figure 4. Installing adjustable foot on support
leg.
-2-
Short
Crossmembers
6.
Stand table upright, and level table by
adjusting feet. Once level, tighten hex nut on
each foot to secure setting (see Figure 5).
Figure 5. Adjustable foot levelling adjustment.
Safety & Correct Use
•
Do not apply an unbalanced load.
•
Keep unsupervised children away from table.
•
Do not stand or climb on table.
•
Do not use in wet or damp locations.
•
Do not leave rags or other items that are
damp with water, oil, paint, or solvents on
table.
•
Set up table in well-ventilated area where
there are no hazardous or combustible
materials that could ignite during welding
operations.
•
While using an electric welder, welder must
be grounded to either workpiece or table
before welding operation. If grounding to
table, workpiece must contact table so cur-
rent may flow through workpiece to ground-
ing clamp and close welding circuit. Ensure
there is some kind of insulation between
operator and electric current (a dry rubber
mat, rubber gloves, etc.).
DO NOT exceed table weight capacity of
500 lbs. Sudden change in dynamic load
at maximum weight capacity could cause
table to tip or collapse, resulting in serious
personal injury or property damage.
Model T28932 (Mfd. Since 12/18)
Hex
Nut
Advertisement
