Product Specifications - AEG AFNDA2565 Original Instructions Manual

a fastener even after the air line is disconnected,
possibly causing injury.
■ Always disconnect air supply:
● before making adjustments
● when servicing the tool
● when clearing a jam
● when tool is not in use
● When moving to a different work area, as
accidental actuation may occur, possibly causing
injury.
LOADING TOOL
■ Do not load the tool with fasteners when any one
of the operating controls is activated.
When loading tool:
● Never place a hand or any part of body in
fastener discharge area of tool.
● Never point tool at anyone.
● Do not pull the trigger or depress the
workpiece contact as accidental actuation
may occur, possibly causing injury.
SAVE THESE INSTRUCTIONS
■ Refer to them frequently and use them to instruct
others who may use this tool. If you loan someone
this tool, loan them these instructions also.
SYMBOL
Safety alert
Please read the instructions carefully before
starting the machine.
Wear ear protection
Wear eye protection
Keep hands away. Keep hands and body
away from the discharge area of the tool.
Hot surface. To reduce the risk of injury or
damage, avoid contact with any hot surface.

PRODUCT SPECIFICATIONS

Operating pressure
Fastener type
Fastener range
Magazine capacity
Air consumption
3
4.8 - 8.3 bar (70 - 120 psi)
15 gauge finish nails
25 - 65mm
100 nails
3.1 L/cycle at 100 psi
Air inlet
Weighted sound
impulse power level
Emission sound
pressure level
Vibration
Weight
DESCRIPTION
1. Adjustable exhaust
2. Selectable trigger
3. Belt hook
4. Quick-connect swivel connector
5. Angled magazine
6. Depth of drive adjustment
7. Pusher
8. Workpiece contact
9. No-mar pad
10. Jam release
11. No-mar pad storage
12. Nose
13. Air hose connector
14. Nails
15. Trigger lever pivot pin
16. Selector in position A
17. Selector in position B
18. To increase depth
19. To decrease depth
20. Inside lever
21. Latch
KNOW YOUR FINISH NAILER
See figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
ADJUSTABLE EXHAUST
The exhaust can be adjusted to a variety of positions
depending on operator preference.
ANGLED MAGAZINE
The angled magazine allows access to tighter areas, and
its rear-loading design offers quick two-step reloading of
fasteners.
BELT HOOK
The hook will rotate to either side of the tool and can be
used to hang the tool from a belt when disconnected and
not in use.
CONSTRUCTION RULER
A construction ruler located along the left side of the
angled magazine allows the operator to make quick
measurements while working.
3/8 in. NPT
92.9 dB(A)
80.6 dB(A)
2.48 m/s
2
1.9 kg