Makita EM408MP Original Instruction Manual page 11

To remove the metal blade, follow the installation
procedure in reverse.
NOTE: The resin part on the blade fastening
nut wears out in course of time. Replace the
nut if there appears any wear or deformation.
Installing the nylon cutting head
CAUTION:
If the nylon cutting head hits
against a stone during operation, stop the
motor and check the nylon cutting head
immediately.
1
2
► 1. Nylon cutting head 2. Receive washer
3. Shaft 4. Hex wrench 5. Tighten
1. Make sure that the receive washer is
attached to the shaft.
2. Insert the hex wrench through the hole in
the gear case.
3. Screw the nylon cutting head onto the shaft.
4. After installing nylon cutting head, remove
the hex wrench.
To remove the nylon cutting head, turn it clock-
wise while holding the receive washer with the
hex wrench.
Mounting the attachment pipe
CAUTION:
Always check that the
attachment pipe is secured after instal-
lation. Improper installation may cause the
attachment falling off from the power unit and
cause personal injury.
5
3
4
Mount the attachment pipe to the power unit.
1.
Turn the lever of the power unit toward the
attachment side.
► 1. Lever
2. Remove the cap of the attachment. Align
the pin with the arrow mark and insert the attach-
ment pipe until the release button pops up.
► 1. Release button 2. Arrow mark 3. Pin
3. Turn the lever toward the power unit side.
1
► 1. Lever
11 ENGLISH
1
1
2
3