Table of Contents
Advertisement
Linksys
Data - SSL Certificate Screen
Export/Restore to/from Local PC
Export SSL
Click to export the SSL certificate
Certificate
Install Certificate
Browse to choose the certificate file Click Install
Certificate button
Export to TFTP Server
Destination File
Enter the name of the destination file
TFTP Server
Enter the IPv4 address for the TFTP server
Export
Click to export the SSL certificate to the TFTP
server
Restore from TFTP Server
Source File
Enter the name of the source file
TFTP Server
Enter the IPv4 address for the TFTP server
Install
Click to install the file to the device
Network Setup Screen
Use this screen to configure basic device settings, VLAN settings and settings
for the LAN interface, including static or dynamic IPv4/IPv6 address assignment
Figure 14: Network Setup Screen
Data - Network Setup Screen
TCP/IP
Host Name
Assign a host name to this access point Host name
consists of 1 to 15 characters Valid characters include
A-Z, a-z, 0-9 and - Character cannot be first and last
character of hostname and hostname cannot be
composed of all digits
VLAN
Enables or disables VLAN function Workgroup Bridge
can only be enabled when VLAN function is disabled
Untagged VLAN
Enables or disables VLAN tagging If enabled (default),
traffic is untagged when VLAN ID is equal to Untagged
VLAN ID and un-tagged traffic can be accepted by LAN
port If disabled, traffic from the LAN port is always
tagged and only tagged traffic can be accepted from
LAN port
By default all traffic on the access point uses VLAN 1, the
default untagged VLAN
Untagged VLAN ID Specifies a number between 1 and 4094 for the
untagged VLAN ID The default is 1 Traffic on the
VLAN that you specify in this field is not be tagged
with a VLAN ID when forwarded to the network
Untagged VLAN ID field is active only when untagged
VLAN is enabled
VLAN 1 is the default for untagged VLAN
M a n a g e m e n t
The VLAN associated with the IP address you use to
VLAN
connect to the access point Provide a number between
1 and 4094 for the Management VLAN ID The default
is 1
IPv4/v6
IP Settings
Select Automatic Configuration or Static IP Address
IP Address
Enter an unused IP address from the address range used
on your LAN
Subnet Mask
Enter the subnet mask for the IP address above
Default Gateway
Enter the gateway for the IP address above
Primary DNS
Enter the DNS address
Secondary DNS
Optional If entered, this DNS will be used if the Primary
DNS does not respond
CHAPTER 2 Access Point Setup
10
Advertisement
Table of Contents
