Table of Contents
Advertisement
Linksys
Location
Enter the area or location where the access point
resides
The location includes 1 to 32 characters Special
characters are allowed
SNMPv1/v2 Settings
Get Community
Enter the name of Get Community Get Community
is used to read data from the access point and not
for writing data into the access point
Get Community includes 1 to 32 characters Special
characters are allowed
Set Community
Enter the name of Set Community Set Community
is used to write data into the access point
The Set Community includes 1 to 32 characters
Special characters are allowed
SNMPv3 Settings
SNMPv3 Settings
Configure the SNMPv3 settings if you want to use
SNMPv3
Username: Enter the username It includes 0 to 32
characters Special characters are allowed
Authentication Protocol: None or HMAC-MD5
Authentication Key: 8 to 32 characters Special
characters are allowed
Privacy Protocol: None or CBC-DES
Privacy Key: 8 to 32 characters Special characters
are allowed
Access Control
Access Control
When SNMP is enabled, any IP address can connect
to the access point's admin page through SNMP
You can enable access control to allow specified IP
addresses Two IPv4 and two IPv6 addresses can be
specified
SNMP Trap
Trap Community
Enter the Trap Community server It includes 1 to 32
characters Special characters are allowed
Trap Destination
Two Trap Community servers are supported: can be
IPv4 or IPv6
SSL Certificate
This screen can be used to manage SSL certificate used by HTTPS
Figure 13: SSL Certificate Screen
CHAPTER 2 Access Point Setup
9
Advertisement
Table of Contents
