Advertisement
Phone Setup
Step 4
Insert the two plastic battery tabs directly into the two battery compartment slots.
Step 5
Use the tab and slot contact point as a pivot to lower the battery into the compartment.
Step 6
Use your finger to press down until you feel and hear the battery clip snap into place.
Related Topics
Remove the Battery
Battery removal follows a reversed but similar procedure to battery insertion.
The steps to remove the battery are the same for both the Cisco Webex Wireless Phone 860 and Cisco Webex
Wireless Phone 840. However, the battery contacts are in different locations on these models. The illustrations
in the following steps are of the Cisco Webex Wireless Phone 860.
Phone Battery
Charging, on page 6
Remove the Battery
Phone Setup
3
Advertisement
