Makita UT1200 Repair Manual page 7

Set the grooved ball bearing (28), work spindle
gearbox housing (18).
insert grooved ball bearings
arbor press. At this time please do not forget to replace the fitting washer (22). Press fit
spindle wheel into gearbox housing
27
28
After setting 1set of 1R258
grooved ball bearing
Press fit grooved ball bearing
housing (3). Please do not forget to place a fitting washer
bearing (28) and spindle wheel (23). Make sure that the square nuts
mounted.
22
And then press the work spindle
(28) with repair tool
(18).
26
28
(V block), press fit shaft (27), intermediate wheel
(28).
28
26
8
3
(28) by arbor press. Then replace gear assembly into motor
(20) and ball bearing
(20) with arbor press. And then
1R030 (Bearing setting pipe 25-17.2) and
(22) between grooved ball
(5)
P 7/ 9
23
(28) into the hole of
(26) and
3
have been