Makita UT1200 Repair Manual page 5

Remove 4 cover caps from end of the upper metal bar and four plugs
Attention: Pressing a
remove 4 plugs(36).
36
Remove four Screws
motor housing (3) while pulling out the interconnecting wire
Release four self-tapping screw
3. Exchange of Carbon brushes
Unscrew disc 4.3(9) and self-tapping screw
nose pliers. Now you are able to pull out whole pair of
red circle as shown below with flat headed screw driver makes more efficient to
(33) (TORX Type). Therefore you are able to separate bow handle
(8) with Torx bit T20. Be careful not to lose square
8
9
17
(21).
(17) and then pull out the terminals with round
brushes5*8(2).
P 5/ 9
(36).
(16)
(5).
2
from