Makita UT1200 Repair Manual page 4

Now you are able to see switch (10), anti-parasite condenser (11), and line cord
screws (13) and wire locking flange (14).
2. Disassembly of Gearing Section
To disassemble gear, prepare Round bar and one set of V-Block (1R258). Press down work spindle
(20) with round bar in drilling direction. During this procedure, please take off the intermediate wheel
(26)
To remove grooved ball bearing 6003 2RS
(1R269) on the side of grooved ball bearing.
14
13
11
10
Arbor Press
Round Bar
20
26
Bearing Extractor
28
(28), make sure to hang the nails of bearing extractor
P 4/ 9
(12), two self-tapping