Honeywell
In the main screen
(Figure
4-6), navigate to ConfigurationNetwork SettingsBasic
Settings and the following window is displayed:
Figure 4-36 Basic Settings
The following parameters can be configured in this window:
DHCP Enable – Check this box to enable DHCP. Or uncheck it to allow users to
configure "IP Address", "Mask" and "Gateway" manually. Then modify the "IP Address",
"Mask" or "Gateway".
Click OK. The system will check if the modified parameters are correct. If the modified
parameters are incorrect it will displayed the message indicating the failure. If all values
entered are correct, the following window is displayed; otherwise, it will pop up error
message.
59