Electromagnetic Compatibility (Emc; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - GE PDM Service Manual

Appendix B– Electromagnetic Compatibility

Electromagnetic compatibility (EMC)

Guidance and manufacturer's declaration –
electromagnetic emissions
Emissions Test
RF Emissions
EN 55011
RF Emissions
EN 55011
Harmonic Emissions
EN 61000-3-2
Voltage Fluctuations/
Flicker Emissions
EN 61000-3-3
B-2
Changes or modifications to this system not expressly approved by GE can cause
EMC issues with this or other equipment. This system is designed and tested to
comply with applicable regulation regarding EMC and must be installed and put into
service according to the EMC information stated in this appendix.
WARNING
Use of portable phones or other radio frequency (RF) emitting
equipment near the system may cause unexpected or adverse
operation.
WARNING
The equipment or system should not be used adjacent to, or stacked
with, other equipment. If adjacent or stacked use is necessary, the
equipment or system should be tested to verify normal operation in
the configuration in which it is being used.
The Patient Data Module is intended for use in the electromagnetic environment
specified below. It is the responsibility of the customer or user to assure that the
Patient Data Module is used in such an environment.
Compliance
Group 1 The equipment uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
Class A
Class A The equipment is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Complies
Patient Data Module
Electromagnetic Environment – Guidance
2030047-001A