Advertisement
Available languages
Available languages
ENGLISH
36
• Confirm your selection with OK. The channel is moved.
• Press EXIT after all required channels have been sorted.
• Select "Yes" when prompted and confirm with OK.
Delete Channels (Delete)
You can delete channels completely from the channel
table.
• Press the "blue" button. DELETE CHANNEL appears
above the list.
• Using the PROG+/PROG- buttons, select the channel
which you want to delete.
• Confirm your selection with OK. The Deletion symbol
appears behind the channel..
• Press EXIT after all required channels have been high-
lighted.
• Select "Yes" when prompted and confirm with OK.
USB Menu
In the "USB" menu, you will find the following submenus:
• USB Information
• Format USB
• Update
USB Information
If a USB storage device is connected, you can display the
total memory and the total available memory on the
device.
Format USB
Here you can format a connected USB storage device.
NOTE: Important!
All data will be deleted from the USB storage device!
• The current available memory is displayed.
• Press OK.
• Select "Yes" when prompted and confirm with OK. The
progress of the deletion process is displayed.
CAUTION:
Do not remove the USB Storage device during the dele-
tion process. This may damage the storage device!
Update
Here you can install new software if required using a USB
Stick.
Cleaning
CAUTION:
No fluids may get into the receiver box. Never clean
with a wet cloth. Before cleaning, disconnect the mains
plug from the mains socket.
CAUTION:
Do not use solvent-based cleaning agents such as
benzine or thinners. These materials may damage the
surface of the housing.
• Clean the housing of the receiver with a dry cloth.
Troubleshooting
Symptoms
Cause
The display is not
The power is
lit.
disconnected.
The Power switch is
not switched on.
No sound or vi-
The receiver is in
sion, Control LEDs
Standby mode.
lit on the receiver.
The Receiver is in
VCR Mode.
The wrong video
signal is being
transmitted.
No sound or vi-
No signal or signal
sion.
is weak.
The TV set is
The receiver is
not displaying a
incorrectly con-
picture.
nected.
The TV set is not
in AV mode.
Poor picture,
The aerial is not
picture hangs.
properly aligned.
Remote does not
The batteries are
work properly.
spent.
The remote is not
pointing at the
sensor.
Solution
Connect the
power cable to
the mains socket.
Switch on the
mains switch.
Press the
STANDBY button
on the remote.
The Receiver
switches on and
the program is
displayed on the
TV screen.
Press the TV/VCR
button.
Press the V-FOR-
MAT button again
to set the correct
video signal.
Check the cable
connection to
the receiver and
from the receiver
to the connected
devices.
Adjust the aerial.
Check the con-
nection of the
Scart or HF cable.
Switch the TV set
to the respective
AV input.
Adjust the aerial.
Replace the bat-
teries with new
ones
Point the remote
at the front of
the receiver and
ensure that noth-
ing is standing be-
tween the remote
and the receiver.
Advertisement
Chapters
