Carrying Tool; Maintenance - Makita M2402 Instruction Manual

► 1. Guide plate 2. Spacer block over 190 mm (7-1/2")
long x 45 mm (1-3/4") wide 3. Workpiece over 85
mm (3-3/8") wide 4. Vise plate
When the cut-off wheel has worn down, raise the cutting
position by putting a spacer block which is slightly nar-
rower than the workpiece as shown in the figure. This
will help you to utilize the cut-off wheel economically.
1
► 1. Vise plate 2. Workpiece diameter 3. Guide plate
4. Spacer block width
Long workpieces must be supported by blocks on
either side so that it will be level with the base top. Use
non-flammable material for supporting blocks.
1
2
3
4
2 3
4
► 1. Supporting block

Carrying tool

Fold down the tool head and lock it. Hold the handle
when carrying.
M2402
M2403

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
11 ENGLISH
1