Signals; Settings - ABB RELION 630 Series Technical Manual

1MRS757256 F
3.2.4.4
3.2.4.5
Table 16: FNKEYMD1 Non group settings (basic)
Name Values (Range)
Mode
PulseTime
LabelOn
LabelOff
PML630/Compact Load-Shedding Solution
Technical Manual
In this mode the output is high for as long as the setting pulse time. After this time the
output returns to "0". The input attribute is reset when the function block detects it
being high and there is no output pulse.
Note that the third positive edge on the input attribute does not cause a pulse, since the
edge was applied during pulse output. A new pulse can only begin when the output is
zero; else the trigger edge is lost.
Input value
Output value
IEC09000332 V1 EN
Figure 28: Sequence diagram for Mode 2
Input function
All the inputs work in the same way. When the LHMI is configured so that a certain
function button is of type CONTROL, the corresponding input on this function block
becomes active, and lights up the yellow function button LED when high. This
functionality is active even if the function block operation setting is set to off.

Signals

Table 14: FNKEYMD1 Input signals
Name
LEDCTL1
Table 15: FNKEYMD1 Output signals
Name
FKEYOUT1

Settings

Unit
Off -
Toggle
Pulsed
0.001 - 60.000 s
0 - 18 -
0 - 18 -
t
pulse
Type Default Description
BOOLEAN 0 LED control input for function key
Type Description
BOOLEAN Output controlled by function key
Step Default
- Off
0.001 0.200
1 LCD_FN1_ON
1 LCD_FN1_OFF
Section 3
Basic functions
t
pulse
IEC09000332_1_en.vsd
Description
Output operation mode
Pulse time for output controlled by
LCDFn1
Label for LED on state
Label for LED off state
49