Figure 5-10. Removing The Accessory Connector; Figure 5-11. Removing The Bottom Cover - Motorola MCS 2000 Service Instructions Manual

5-8 Disassembly & Reassembly and Replacement Procedures: Disassembly to Transceiver Board Level
3. Remove the Accessory Connector by sliding a finger into the recess on the bottom cover and
pushing up on the connector tab to loosen the connection. Lift the connector out of the
recess.
4. Insert a wide flat-blade screwdriver or like instrument in the recess area on the side of the
radio near the antenna and power connector ends (see
5. Pry the bottom cover off the chassis by pushing the handle of a screwdriver up and toward
the radio. This will disengage the snap between the bottom cover and the chassis.
6. Repeat Step 4 and Step 5 for the other side of the radio.
7. Rotate the bottom cover out and away from the chassis until it is completely free of the chas-
sis taking care not to damage the 18 position connector in the process.
Rotate Cover
Out and Away
in this Direction
18 Position Connector
8. Remove the cover gasket from the chassis.
Note the correctly assembled position of the main seal before removing.
December 6, 2004
See Figure 5-10.
2) Pull connector
straight out
2) Pull connector
straight out
Bottom Cover
Bottom Cover

Figure 5-10. Removing the Accessory Connector

Rotate Cover
Out and Away
in this Direction
10 Position Connector

Figure 5-11. Removing the Bottom Cover

1) Slide finger
under tab
1) Slide finger
under tab
Accessory Connector
Accessory Connector
Figure 5-11).
Disengage Snap here
Disengage Snap here
and on other side
and on other side
68P81083C20-D