Disassembly & Reassembly and Replacement Procedures: Disassembly to Transceiver Board Level
Front
Antenna Connector
Retaining Clip
Figure 5-8. Removing the Transceiver Board (800 MHz and 900 MHz only)
Disassembly to Transceiver Board Level High Power Models
!
C a u t i o n
Remove the Bottom Cover
1. Disconnect the Remote Mount Cable by squeezing the top and bottom of the connector
together, disengaging the bottom snap then the top, and pulling straight out.
2. Flip the unit over so that the Bottom Cover is facing up.
68P81083C20-D
PA Holding Screws (2)
Accessory Connector Detail
DO NOT attempt to disassemble the radio without first
referring to the CMOS Precautions paragraph on page 2-2 in
the Maintenance section.
Top
Front
Front
Figure 5-9. Direction Conventions
Board Holding Screw
(To be removed last)
Power Connector
Retaining Clip
1) Slide finger
under tab
2) Pull connector
straight out
Top
Bottom
Bottom
Back
Back
December 6, 2004