Disassembly To Transceiver Board Level High Power Models; Remove The Bottom Cover; Direction Conventions; Removing The Accessory Connector - Motorola MCS 2000 Service Instructions Manual

Disassembly to Transceiver Board Level
High Power Models
!
C a u t i o n
Remove the
Bottom Cover
DO NOT attempt to disassemble the radio without first referring to the
CMOS Precautions paragraph on page 2-2 in the Maintenance section.
1. Disconnect the Remote Mount Cable by squeezing the top and bottom
of the connector together, disengaging the bottom snap then the top,
and pulling straight out.
2. Flip the unit over so that the Bottom Cover is facing up.
Front
Figure 5-9
3. Remove the Accessory Connector by sliding a finger into the recess on
the bottom cover and pushing up on the connector tab to loosen the
connection. Lift the connector out of the recess. See Figure 5-10.
Bottom Cover
Figure 5-10
Disassembly & Reassembly and Replacement Procedures
Top

Direction Conventions

1) Slide finger
2) Pull connector
straight out under tab
Accessory Connector

Removing the Accessory Connector

Back
Bottom
5-7