Operation - Makita TD021D Instruction Manual

1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
► Fig.9: 1. Bit 2. Bit-piece 3. Sleeve
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.

OPERATION

► Fig.10: 1. Straight type 2. Pistol type
The tool can be used in two ways; a straight type and a
pistol type which is selectable according to the condi-
tions of workplace and screwdriving.
CAUTION:
• When bending the tool to use in the pistol type
or straightening to use in the straight type, do
not hold the bendable part of the tool. Failure to
do so may cause your hand and fingers to be
pinched and injured by this part.
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
N m
(kgf cm)
20
(204)
15
(153)
10
(102)
5
(51)
0
Fastening time S)
High tensile bolt
N m
(kgf cm)
20
(204)
15
(153)
10
(102)
5
(51)
0
Fastening time S)
7 ENGLISH
M8
(M8)
M6
(M6)
1.0 2.0
(
M6
(M6)
1.0 2.0
(
3.0
3.0