Cisco Rainier Satellite D9865 Quick Tips page 3

D - h - b receiver

Hide thumbs Also See for Rainier Satellite D9865:

Scroll Down to Preset Name to name of the new programing service. Press the

BUTTON. You can enter the letters using the remote Keyboard or push the up the down arrow keys

to scroll through both lower and upper case letters. Once name is entered go to OK and press OK on

remote.

Scroll past LNB Configuration as it already set to 1 which is 5150Mhz (C band LNB ) stop on

MODULATION TYPE. Using the left or right arrow set it to DVB-S2 or DVB-S as required by the service,

Press OK.

Scroll Down to DOWNLINK and enter in the the Frequency of the transponder. Make sure you enter

any leading ZERO, so 4 GHz is 04.00000 Ghz. If your tuning Ku band there is no leading ZERO example

12.110000 GHZ, Click OK to enter.

Scroll down to SYMBOL RATE and click OK, Then enter the number (example 30000 MS) then click OK

again.

Scroll down to NetId, Click OK and enter the NET ID. Rainier provides the proper NET ID number for our

subscription services. NetId for a FTA services is usually 1 or 0.

Once everything is entered correctly, position your dish on the satellite and polarity of the service you

want to view, using either your Rainier approved dish moveror other mover. Proper polarity with our

ortho feed / Diseqc setup will be selected using proper LNB configuration for group. (see Harvard

Scientific Ortho Feed Hookup and 9865 Configuration document) If you're using a servo feed make sure

your polarity degree is set correctly. Then Press the

transponder in. You will get a warning, Changes may affect system settings sc reen , do not worry just

Press OK. If you're on the right satellite and polarity you will see Acquisition S uc c e s s f u l or

Acquisition Failed. If it failed check the satellite dish position and polarity setting on your Rainier

approved mover, 4DTV master receiver or other mover. With DVB-S2 polarity and position has to be

exact, and this can be touchy sometimes. Tune slowly, if your dish is tracking the arc properly and you

using the proper equipmentyou should have no problem getting reception. If you still have problems

contact your local dish installer, Satellite Dealer or Rainier customer supportfor more information.

BLUE

button to A CT I V A T E this scans that

RED

KEYBOARD