Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Removing transit bolts
1. Before operating the washer, remove the
transit bolts (4 each) along with the rubber.
• If the bolts are not removed, it may cause
heavy vibration, noise and malfunction.
3. Close the holes with the Blanking Caps supplied.
Location of washer
• Check the location where the machine will be installed. Make sure you have everything necessary
for correct installation.
• Do not place or store your washing machine below 0°C (32°F) to avoid any damage from
freezing.
• Never place/store laundry products on top of the machine.
• Install the washer on the horizontal solid floor.
If the washer is installed on an uneven floor, it could make
considerable noise, vibrate severely and cause a malfunction. If the
machine is not level, adjust the legs up or down for horizontal
installation.
• Ventilation openings must not be obstructed by carpeting when the
machine is installed on a carpeted floor.
• Leave some space (right & left : 2cm, rear : 10cm).
• In case of built-in installation, the distance between top of the washer and bottom of upper plate
2. Unscrew the 4 bolts with the spanner
supplied. Keep the 4 bolts and spanner for
future use.
• Whenever the appliance is transported, the
transit bolts must be refitted.
4
Drain Hose
Washer
Laundry
Tub
approx.
2cm
Advertisement
Table of Contents
