Replacing The Water Filter; Troubleshooting - Baumatic TITAN2 Instruction Manual

Replacing the water filter

o IMPORTANT: Before commencing this process, please
disconnect your appliance from the mains and turn off the water
tap.
o Remove the water filter from the filter holder and then
disconnect the inlet hose from either end of it.
o Connect the inlet hose back to either end of the new filter, and
then insert the filter back into the filter holder.
o Turn back on the water tap and with dry hands reconnect the
appliance to the mains. Check for leaks and then dispense water
from the appliance.

Troubleshooting

IMPORTANT: If your fridge freezer appears not to be
operating properly, before contacting the Baumatic
Service Department, please refer to the checklist
below.
My fridge freezer does not appear to be working/there
is no power to my appliance.
o Check that the plug is fully inserted into the power socket.
o Check that there is power to your mains supply (e.g. that there
hasn't been a power cut or that the fuse hasn't blown).
o Check that your mains supply voltage, corresponds to the
voltage stated on the rating plate of your appliance.
My fridge freezer appears to be performing poorly
o Check that the appliance isn't overloaded and that food hasn't
been packed too tightly into it.
o The thermostat setting is too low; you should turn the
thermostat up higher.
o Ensure that the door is closing properly and that the door has
not been opened for a prolonged period in error.
o Ensure that there is adequate ventilation for your appliance.
40