o When you are confident that there are no bends in the water
inlet or no leaks, replace the rear cover. You should make sure
that the water inlet sits between the groove of the refrigerator
back and the compressor cover.
IMPORTANT- Check for all connections and make sure that there is
no sign of leaks before placing the appliance in its final location. You
should ensure that the inlet hose does not get crushed or kinked.
6) Fasten the water inlet in an
appropriate position using the fastener
provided. IMPORTANT- You must
make sure that the water inlet does
not get bent or squeezed by being
fastened.
7) Connect your appliance
to your mains supply and
then press the
WATER/ICE button for 2
– 3 minutes; this will
remove any airlocks in the
water inlet and any initial
water that has entered the
appliance whilst you were
installing it to the water
supply.
38