Positioning - Baumatic TITAN2 Instruction Manual

Positioning

o It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN
N
ST
T
o Positioning the appliance requires two persons in order to avoid
injuries or damage to the appliance.
o Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler). If this is not feasible, then you
should install an insulation plate between the appliance and the
adjacent heat source.
o You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o Place the appliance flatly and firmly on a solid base. The
appliance is fitted with adjustable feet on the front side, which
can be used to level the appliance.
o The rear side of the appliance is fitted with wheels which
facilitate the positioning of the appliance into its final location.
o Anything positioned above the appliance must be at least 15 cm
away to allow sufficient cooling of the condenser. You must allow
a 5cm gap to the rear and side of the appliance.
o If you are placing another cooling appliance next door to this
product, then there must be a gap of at least 5 cm between the
appliances. This will help to prevent condensation from forming.
o Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury.
+10 to +32 degrees centigrade
+16 to +32 degrees centigrade
+18 to +38 degrees centigrade
+18 to +43 degrees centigrade
29