Makita LF1000 Instruction Manual page 14

1. High table set up
1. Hook
2. Feet
3. Stopper hook
006043
To set up the tool with high table, proceed as
follows.
(1) Fall down the tool carefully BACKWARDS
without fail while holding it with both hands.
(2) Turn the hook in the direction of arrow in the
figure to unbundle the feet. Open the table
feet on one side and push the bottom bar of
the feet forward fully to be locked by itself.
Take the same procedure for the feet on the
1. Stopper hook
2. Feet
3. Hook
006044
The feet can be folded as shown in the figure. To
fold down the tool, do as follows.
(1) Fall down the tool carefully BACKWARDS
without fail while holding it with both hands.
(2) Pull up first the stopper at the joint of left feet
toward yourself to unlock it.
2
1
WARNING:
•
2. Low table set up
1
2
14
opposite side. Make sure that the feet at both
sides are completely locked.
Make sure that the stopper hooks are perfectly
positioned in the groove of the bracket.
(3) Return the tool to the upright position.
3
(3) Take the same steps for the opposite feet as
above.
(4) Use a hook to bundle these feet.
(5) Return the tool to the upright position.
3