Installation; Checking Your Repeater For Damage - Honeywell Notifier IDR-2P User Manual

To avoid damage to the IDR
repeater and to the fire
control panel, ensure that
you follow these
997-411-000-9, Issue 9
March 2008
IDR-2P, -2A & -6A Repeaters User Manual
instructions
6

2.3 Installation

The IDR repeater is relatively simple to install
providing the recommended procedures
described in this Installation Guide are
followed.
Follow all installation instructions
described in
instructions must be understood and the
manufacturer's recommendations followed
to avoid damage to the IDR repeater, the
fire control panel and associated equipment.
2.3.1 Checking Your Repeater for
Damage
It is important to check all supplied
equipment for damage before proceeding
with the installation!
Before attempting to install your IDR repeater,
you should do the following:
1 After removing the IDR repeater from its
packaging, and before you proceed with
installing it in its chosen location, check for
any damage that may have been caused
while in transit.
Note: In the unlikely event that the IDR
repeater supplied has been damaged,
you MUST NOT install it but return it to
your supplier. The procedure for
returning faulty items is described in
Section 2.3.2, What to do if Your
Repeater is Damaged or Suspect.
2 If you are satisfied that the IDR repeater
has NOT been damaged you can now
commence the installation procedure. This
manual describes the recommended
installation methods of the IDR repeater.
Refer to the relevant sections that apply to
your configuration requirements.
To prevent unnecessary damage to the
electronic components, place a cover over the
front door while you fit the enclosure to the
wall. Refer to Section 2.5.1, Fixing Enclosure
to Wall for details.
this manual. These