Isolated Rs232 Board (Option) - Honeywell Notifier IDR-2P User Manual

Observe precautions for
handling Electrostatic
Sensitive Devices
1 & 2
3
TWO-PART
CONNECTOR FOR
EQUIPMENT
IDR-2P, -2A & -6A Repeaters User Manual
ATTENTION
CONNECTION
TO TERMINATION
BOARD
11
2.6 Isolated RS232 Board (optional)
This board is required only if Notifier-approved
equipment is to be connected to the IDR repeater.
To fit the Isolated RS232 Board:
1 Use a hex key to open the IDR repeater
door (A).
2 Orientate the Isolated RS232 Board (B) as
shown and secure it to the IDR repeater
enclosure (C) using the four M3 X 8 SEM
screws (D) supplied with the Board.
Note: The Board is supplied with additional
fixings for other applications. These can
be discarded.
3 Connect the wiring (see drawing opposite).
a. Use screened multi-core cable to
connect the equipment.
b. Use the supplied ribbon cable to
connect to the Termination Board.
To remove the Isolated RS232 Board, reverse
the procedure for fitting it.
997-411-000-9, Issue 9
March 2008