Optima - G 1262; Table 080-33: Service Mode Summary, G 1202 - Miele G 1 Series Technical Information

Technical Information
Options:
Function
Software version ID
check
Display and delete fault
memory
Component test
Operating hours check
LED test

Table 080-33: Service Mode Summary, G 1202

4.3.3

Optima - G 1262

Initial requirements:
1. Open the door.
2. Switch off the appliance.
Accessing:
1. Press and hold the Program button.
2. Switch on the appliance.
3. Release the Program button.
4. Immediately press the Program button 3 times; on the 3rd time, hold until
the "Rinse & Hold" LED flashes (1 flash per second).
5. Release the Program button.
6. If the "Rinse & Hold" LED does not light up, repeat the procedure.
Programming
Do not press the Delay
Start button. The "Delay
Start" LED is not lit.
Press the Delay Start
button 1x. The "Delay
Start" LED flashes 1x
quickly intermittently.
Press the Start/Stop
button. Press it again to
display saved faults. To
delete the fault memory,
press the Start/Stop
button again and hold it for
4 s.
Press the Delay Start
button 2x. The "Delay
Start" LED flashes 2x
quickly intermittently.
Press the Start/Stop
button. Press it again to
activate the next
component.
Press the Delay Start
button 3x. The "Delay
Start" LED flashes 3x
quickly intermittently.
Press the Delay Start
button 4x. The "Delay
Start" LED flashes 4x
quickly intermittently.
Press the Start/Stop
button 1x.
210
G 1xxx/G 2xxx
Display
"Rinse" LED is out or flashes. The
display shows the software version
ID no. in consecutive digits
(e.g., -1304).
"Rinse" LED is off or flashes. The
display shows F and a fault code
number alternately. If the fault
memory is empty, F and 0 are
displayed alternately.
The display shows which
component is being tested. For
example, if drain pump M8 is being
tested, U and 3 are shown
alternately. For the test sequence
and background information about
individual components and their
activation, see Section 080-2.2.
The display shows the number
of operating hours as follows: If the
appliance has run for 74 hours, h, 7
and 4 are displayed alternately.
The display shows 6.1. All LEDs
light up.