Honeywell SS4-AI Installation Manual And Operating Manual page 19

TABLE 2: Configuration Dip Switch Settings
Verification Time
DIP SWITCH
1
closed
closed
open
closed
open
closed
open
open
Latching
DIP SWITCH
4
open
closed
Test Cycle
DIP SWITCH
6
open
closed
Fire Range
DIP SWITCH
7
open
closed
open
HONEYWELL
DIP SWITCH DIP SWITCH
2 3
closed closed
open open
closed open
closed open
open closed
open closed
closed closed
open open
Non-Latching mode. If Verify is enabled then the Verify Relay will de-energize
approximately 10 seconds after it energizes. If Verify is disabled then the Fire
Relay(s) will de-energize approximately 10 seconds after it energizes.
Latching mode. If Verify is enabled then when the Verify Relay energizes it will
remain energized until the detector is reset. If Verify is disabled then when the
Fire Relay energizes it will remain energized until the detector is reset.
Factory setting.
DESCRIPTION
Testing of the Lens occurs every 30 minutes. Factory setting.
Testing of the Lens occurs every 6 minutes
DIP SWITCH
DESCRIPTION
8
open The detector is set to detect an industry standard 1 sq. ft. fire at
15 feet on axis.
open The detector is set to detect an industry standard 1 sq. ft. fire at
30 feet on axis.
closed
The detector is set to detect an industry standard 1 sq. ft. fire at
45 feet on axis.
OPERATOR MANUAL // SECTION 3: MAINTENANCE AND
DESCRIPTION
Verify is disabled & the Verify Relay is unused.
Factory setting.
Verify is enabled and the Verify time is 5 seconds.
Verify is enabled and the Verify time is 10 seconds.
Verify is enabled and the Verify time is 15 seconds.
Verify is enabled and the Verify time is 20 seconds.
Verify is enabled and the Verify time is 25 seconds.
Verify is enabled and the Verify time is 30 seconds.
Verify is disabled and the Verify Relay operates as a
second Fire Relay.
DESCRIPTION
TROUBLESHOOTING
18