Honeywell Lyric User Manual

This wireless heat / smoke
detector is intended for use with
Honeywell controls that support
SiX™ series devices.
FC: This wireless heat / smoke
detector is intended for use with
Honeywell controls that support
SiX™ series devices.
SP: This wireless heat / smoke
detector is intended for use with
Honeywell controls that support
SiX™ series devices.
PA: This wireless heat / smoke
detector is intended for use with
Honeywell controls that support
SiX™ series devices.
NOTE: Once enrolled, the device
cannot be used with another
system until it is removed from
the current controller. See the
controller's instructions,
FC: NOTE: Once enrolled, the
device cannot be used with
another system until it is
removed from the current
controller. See the controller's
instructions,
SP: NOTE: Once enrolled, the
device cannot be used with
another system until it is
removed from the current
controller. See the controller's
instructions,
PA: NOTE: Once enrolled, the
device cannot be used with
another system until it is
removed from the current
controller. See the controller's
instructions.
To silence the detector: Press the test switch or disarm the system at the
controller. If the alarm condition continues, the detector
is only quiet for 5 minutes. When programmed in one-go-
all-go mode, the test switch will not silence the detector.
AGENCY STATEMENTS ARE AT THE BOTTOM
OF PAGE 2
Smoke Detector Open
/ OPEN
OPEN / OPEN
Enroll / Enroll / Enroll / Enroll
NOTE: After enrolling and before mounting permanently,
conduct Go/No Go tests (see controller's instructions) to
verify adequate signal strength. Adjust the device location
and orientation as necessary.
FC: NOTE: After enrolling and before mounting
permanently, conduct Go/No Go tests (see controller's
instructions) to verify adequate signal strength. Adjust the
device location and orientation as necessary.
SP: NOTE: After enrolling and before mounting
permanently, conduct Go/No Go tests (see controller's
instructions) to verify adequate signal strength. Adjust the
device location and orientation as necessary.
PA: NOTE: After enrolling and before mounting
permanently, conduct Go/No Go tests (see controller's
instructions) to verify adequate signal strength. Adjust the
device location and orientation as necessary.
For programming Smoke or Heat alarms and Tamper, see the Controller's instructions.
NOTE: All smoke detectors programmed in the panel to operate in one-go-all-go mode will
sound on alarm.
FC: For programming Smoke or Heat alarms and Tamper, see the Controller's
instructions.
NOTE: If programmed in the panel to operate in one-go-all-go mode, all smoke detectors in the
system will sound on alarm
SP For programming Smoke or Heat alarms and Tamper, see the Controller's instructions.
NOTE: If programmed in the panel to operate in one-go-all-go mode, all smoke detectors in the
system will sound on alarm
PA: For programming Smoke or Heat alarms and Tamper, see the Controller's
instructions.
NOTE: If programmed in the panel to operate in one-go-all-go mode, all smoke detectors in the
system will sound on alarm
*
Use UL/ANSI Approved canned smoke. / Use UL/ANSI Approved canned smoke. /
Use UL/ANSI Approved canned smoke. / Use UL/ANSI Approved canned smoke.
Mount / Mount /
Mount / Mount
Test / Test
/
Test / Test