Yamaha MT-09 Owner's Manual page 68

3
4
4
1. Bolt
2. Coolant reservoir cover
3. Coolant reservoir
4. Collar
6. Remove the coolant reservoir cap.
1. Coolant reservoir cap
7. Drain the coolant from the coolant
reservoir by turning it upside down.
Periodic Maintenance And Adjustment
8. Install the coolant reservoir and its
cover by placing them in the original
position, and then installing the
1
collars and bolts.
9. Remove the coolant drain bolt and
its gasket to drain the coolant from
the cooling system.
1
2
1 2
1. Coolant drain bolt
1
2. Gasket
10. After the coolant is completely
drained, thoroughly
cooling system with clean tap water.
11. Install the coolant drain bolt and its
new gasket, and then tighten the
bolt to the specified torque.
Tightening torque:
Coolant drain bolt:
10 N·m (1.0 kgf·m, 7.2 lb·ft)
12.
Antifreeze/water mixture ratio:
Recommended antifreeze:
Coolant quantity:
13.
14.
15.
16.
flush the
17.
7-17
Pour the specified amount of the
recommended coolant into the
radiator and reservoir.
1:1
High-quality ethylene glycol anti-
freeze containing corrosion inhibitors
for aluminum engines
Radiator (including all routes):
1.93 L (2.04 US qt, 1.70 Imp.qt)
Coolant reservoir (up to the maxi-
mum level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
Install the coolant reservoir cap.
Install the radiator cap.
Start the engine, let it idle for
several minutes, and then turn it off.
Remove the radiator cap to check
the coolant level in the radiator. If
necessary, add sufficient coolant
until it reaches the top of the
radiator, and then install the
radiator cap, radiator cap retainer
and radiator cap retaining bolt.
Check the coolant level in the
reservoir. If necessary, remove the
coolant reservoir cap, add coolant
7